Manuals / Hobart / Kitchen Appliance / Freezer

Hobart ML-124066, ML-124068, HQC90, HQCF45, ML-124067 manual Hr Min Sec Remove all chilled product

Models: ML-124067 ML-124066 HQCF45 HQC90 ML-124068

1 32

Page 13

HOLDING		AIR: 14°F
1	39°F	42°F 3
2	44°F
0:00:11		STOP/RESET

NONE RECORD

PRINTING

PLEASE WAIT...

MAIN MENU

•The total time since the cycle was finished is displayed

— Hr: Min: Sec.

•Remove all chilled product.

•Press STOP/ RESET.

•Select NONE to continue without printing.

•Select RECORD to print a Chill Report. If equipped with the optional label printer, refer to the alternate Print menu below. NOTE: Chilling BY TIME does not retain Product Probe temperature data in memory and will not print TEMP vs. TIME information.

RECORD

LABEL

NONEBOTH

•After printing or selecting NONE, return to Main Menu.

•If equipped with the optional label printer, an alternate Print menu, shown at left, permits the choice of printing

. . . RECORD, LABEL or BOTH . . . types of reports.

– 13 –

Page 13

Image 13

Hobart ML-124066, ML-124068, HQC90, HQCF45, ML-124067 manual Hr Min Sec Remove all chilled product

Contents

HQCF45 QUICKCHILLER-FREEZER HQC45 & HQC90 QUICKCHILLERSMODEL HQC45 ML-124066 HQCF45 ML-124067 HQC90 ML-124068TABLE OF CONTENTS Page HQC45 & HQC90 QuickChillers Installation, Operation, Use and Care ofHQCF45 QuickChiller-Freezer GENERALUNCRATING INSTALLATIONLEGS OR CASTERS Door Switch FEATURESFan Door Switch LOCATIONINSTALLATION CHECKOUT INSTALLATION OF REMOTE ALARM OptionalELECTRICAL CONNECTIONS OPERATION OVER TEMPERATURECONTROLS Fig START-UPPRINTER SUPPLIES WHEN POWER IS RESTORED AFTER A POWER INTERRUPTIONLOADING ROLL STOCK ONTO THE PRINTERS Fig Plain Thermal PaperMAIN MENU the display goes to If all probes are ‘done,’HOLDING number to stop cycleMAIN MENU BY TIME - Timer counts down until cycle is doneFrom the Main Menu, select BY TIME Hr Min Sec Remove all chilled product From the Main Menu, select BY PROD MAIN MENUFollow the cycle run information on pages beginning atbeginning at PRODUCT LIST From the Main Menu, select MORE and HOLD PROD chilling but only if operating in Holding mode DEFROSTPRODUCTS SETUPSETUP USERSSYS PAR CLOCK TEMPS IN F PROBESLOGGING REMOTE ALARM Access the Sys Par 2 menu as shown on page ALARMSFrom Sys Par 2, select ALARMS CHILL MODEMODE Access the Sys Par 2 menu as shown on pageSet the AIR Temp using the ↓ or ↑ keys Set the TARGET Temp using the ↓ or ↑ keysSet the HOLD Temp using the ↓ or ↑ keys Set the HIGH ALARM Temp using the ↓ or ↑ keysBUZZER FAC PRESETSGLOSSARY During communication with the SmartChill program COMMUNICATION WITH SmartChillon a PC, the screen at left displays CLEANING MAINTENANCEERROR MESSAGES MAINTENANCE PROGRAM