•Access the Sys Par 1 menu as shown on page 21.
SYS PAR 1 | 09:07:31 |
|
|
|
CLOCK TEMPS IN °F |
|
|
| |
PROBES | LOGGING |
|
|
|
SETUP MENU | MORE | SYS PAR 2 | 09:08:41 | |
|
| REMOTE ALARM MODE | ||
|
| ALARMS |
| BUZZER |
|
| BACK | FAC PRESETS | |
PROBES
SELECT PROBE: |
|
| |
1 | ON | ON | 3 |
2 | ON | N/A | 4 |
CANCEL | ENTER | ||
TEMPS IN °F
SYS PAR 1 | 09:07:31 |
CLOCK TEMPS IN °F | |
PROBES | LOGGING |
SETUP MENU | MORE |
LOGGING
SELECT DATA LOGGING
INTERVAL:
↓ | 5 MINUTE(S) | ↑ | |
| CANCEL | ENTER |
|
•From Sys Par 1, select PROBES.
(Probe #’s 1 – 3 should be ON.)
(Probe 4 is marked N/A; Not Available.)
•Select any probes marked OFF to turn them ON.
•Select ENTER to save any changes.
(CANCEL returns to SYS PAR 1 without saving any changes.)
•From Sys PAR 1:
(TEMPS IN °F indicates the control uses Fahrenheit temperatures.)
•If TEMPS IN °C is displayed, select it to change the control from Celsius to Fahrenheit temperatures.
•From Sys Par 1, select LOGGING.
•Use the ↓ or ↑ keys to set the Data Logging Interval. This determines how often the data will be logged in memory. Range = 5, 10, 15, or 30 Minutes.
•ENTER accepts the change and returns to SYS PAR 1.
•CANCEL reverts back to the previously entered Data Logging Interval and returns to SYS PAR 1.
– 23 –
