HoMedics USL-1000-EU Using Your Ultraslim PRO, UltraSlim Pro Control Panel and Functions

IB-USL1000EU-0413-02_Layout 1 02/05/2013 17:02 Page 8

USING YOUR ULTRASLIM PRO

UltraSlim Pro Control Panel and Functions

Treatment zone Indicators	MODE: Select preset
	treatment zone

Start/Pause treatment

Timer Display (minutes)

Intensity Display
(Level)	Increase or decrease	Increase or decrease
	treatment time	intensity level

Beginning a treatment session

Once you have plugged the machine into the mains supply and turned on the power switch (reverse of unit), the following default settings will appear on the monitor:

Treatment Zone: Abdomen Time: 15 minutes Intensity: Level 4

To scroll through the different treatment zone press . The LED for the selected zone will illuminate. N.B. The treatment zone cannot be changed once treatment starts.

With the required Treatment Zone, Level and Time selected you are ready to begin. First ensure sufficient gel has been applied to the treatment area, remove the Ultrasound applicator from the bracket and press to start treatment

With the metal surface of the Ultrasound applicator, massage the area using the techniques shown on the next page.

To pause treatment press and simply press again to restart the treatment .

If the session is not restarted within 5 minutes the device will emit a beep and enter standby mode. To reactivate press to recall the session and to continue treatment.

Once the timer reaches zero, the treatment will stop and the unit will emit a double beep.

Customising your treatments

The preset time and intensity levels take into account the amount and depth of fat normally located in the specific treatment areas and are therefore recommended for normal use.

The table below provides guidelines for the pre-set treatment times/levels.

Treatment area	Pre-set time	Power level
Abdomen/lower back	15 mins	4
Thighs/Legs	10 mins	3
Buttocks	12 mins	4
Upper arm	8 mins	3

GB

8