IB-USL1000EU-0413-02_Layout 1 02/05/2013 17:02 Page 11

After Treatment Care:

After you have finished your treatment clean any gel from the handset using a damp, but not wet, cloth. Return the handle to the cradle. Switch off the unit using the switch at the back of the machine and unplug from the mains.

Remove any excess gel from the skin with a damp cloth. If you wish to apply anti-cellulite or toning creams/gels after treatment is a good time to do this.

For best results it is recommended to take 20-30 minutes of light exercise e.g. walking/cycling/swimming etc. to assist with drainage of the lymphatic system.

Ultrasound Re-Calibration Process

To prolong the life of the unit it is necessary to periodically re-calibrate the frequency. This ensures that the applicator and main unit are operating at the same frequency to deliver the best treatment results.

It is recommended to carry out this process at least every 100 working hours, but it does not matter how often you check the calibration. If the tingling sensation felt during use reduces in intensity over time this may indicate that the unit requires recalibration.

Calibration process:

1.To enter calibration mode first turn the unit on. Select a treatment mode and press to activate the

ultrasound. Press and hold both up and down arrows (Level) . The frequency will display on the screen.

2.The frequency should be set to 40 to maximise the performance of the device. Use to change the frequency if it is above or below 40

3.After changing the frequency, press to save the changes. If frequency is already at 40, go to the next step.

4.Press together to exit the frequency calibration interface, then the device will go to the standby status.

Measurement Chart:

Use the below table to keep track of your treatments and record circumference reduction. Either complete the table on this page or photocopy.

Treatment/

Measurement Date

Treatment Area

Circumference

Notes

11

GB

Page 11
Image 11
HoMedics USL-1000-EU After Treatment Care, Ultrasound Re-Calibration Process, Calibration process, Measurement Chart