Roland XP-30 owner manual Getting Ready, Following diagram

Getting Ready

1	Before installing the Wave Expansion Board, turn off the
		If the same type of Wave
	power of the XP-30 and all connected devices, and disconnect
		Expansion Board is
	all cables from the XP-30.
		installed in the EXP-D slot
		and the EXP-E slot, it will
2	Turn the XP-30 on its back, and remove only the screws shown	only be possible to select
		data from the Wave
	in the following diagram.	Expansion Board that was
fig.Q-02a.e		installed in the EXP-D slot.

Screws to be removed	Also, the XP-30 already
	contains the data of the
	following three Wave
	Expansion Boards, so if one
	of these Wave Expansion
	Boards is installed, only the
	internal data (XP-A–C) can
	be selected.
	SR-JV80-09 “Session”
	(XP-A)
	SR-JV80-02 “Orchestral”
	(XP-B)
	SR-JV80-11 “Techno
	Collection” (XP-C)

3	Inside, there are two connectors and six board holders. Insert
	the connectors of the Wave Expansion Board into the internal
	connectors, and simultaneously insert the board holders into
	the holes of the Wave Expansion Board.
fig.Q-02b.e
	Wave Expansion Board

Board holder	EXP E
Connector	EXP D

Quick Start

17