Roland XP-30 Turning On the Power, Before you turn the power on, check to make sure that

Getting Ready

Turning On the Power

1 Before you turn the power on, check to make sure that:

•All external devices are correctly connected to the XP-30.

•The volume controls of the XP-30 and the amp/mixer system are turned down all the way.

2	Turn on the power switch located on the rear panel of the XP-
	30.
fig.Q-06

3	Turn the power on of your amp or audio system.
4	Play the XP-30 and gradually raise the volume controls of the
	XP-30, your amp or mixer to an appropriate volume level.
fig.Q-07

■Turning Off the Power

1Before you turn power off, check to make sure that:

•The volume controls of the XP-30 and the amp/mixer system are turned down all the way.

•Important data has been saved to a memory card (p. 122).

2Turn off your amp/mixer system.

3Turn off the XP-30 power.

Once the connections have been completed (p. 24), turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices.

This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally.

Be careful not to raise the VOLUME slider of the XP- 30 too much. Excessive volume may damage your amp/speaker system or could cause hearing

26