Roland XP-30 Transmitting Data to User Memory, 120, Type Data Type, Block Source Block

Chapter 4. Memory Settings (Utility/Card Mode)

Specifies the data to be transmitted through the combinations as shown below.

For example, if you wish to transmit the USER group Patches 001–020, you would specify “PATCH USER:001-020.”

Type	Block
ALL	USER
	TEMP
PERFORM	USER	01–32
	TEMP	-PATCH	*1
		+PATCH	*2
	CTRL
PATCH	USER	001–128
	TEMP
RHYTHM	USER	001–002
	TEMP
SYSTEM	USER

*1 The current Performance

*2 The current Performance and the Patch or Rhythm Set assigned to each Part of the Performance

Type (Data Type)

Specify the type of data to be transmitted.

ALL: Performance, Patch, and Rhythm Set

PERFORM: Performance

PATCH: Patch

RHYTHM: Rhythm Set

SYSTEM: System

Block (Source Block)

Specify the source of the data to be transmitted. USER: Transmit the data from user memory. TEMP: Transmit the data from the temporary area. CTRL: Transmit messages for Performance bank select,

Performance program change, and Volume and Pan messages for the Parts whose Rx parameter (PERFORM/MIDI/MIDI) is turned ON.

Specifies the data to be transmitted through the combinations as shown below.

For example if you wish to transmit only the PR-A group Patch 001, specify “PATCH PR-A:001-001”

*If the specified data will not fit completely into the transmission destination, as much of the data as will fit will be transmitted, starting at the first number of the specified transmission destination.

(Example)
Block	PATCH PR-A:001—005
Destination	User:127

If the above settings are made and transmission is executed, only the two PR-A group Patches 01 and 02 will be transmitted to USER group Patches 127 and 128.

Type	Block
ALL	PR-A
	PR-B
PERFORM	USER	01–32
	PR-A, B	01–32
	CARD	**	*1
PATCH	USER	001–128
	PR-A–C, GM, PR-E	001–128
	XP-A, B	001–255
	XP-C	001–256
	XP-D, E	001–***	*2
	CARD	**	*1
RHYTHM	USER	001–002
	PR-A–C, GM, PR-E	001–002
	XP-A, C	001–008
	XP-D, E	001–***	*2
	CARD	**	*1
SYSTEM	Card	**	*1

*1 Specified by file number

*2 Depends on the Wave Expansion Board installed

Destination

Set the transmission destination to MIDI.

■Transmitting Data to User

Memory

You can transmit Patch, Performance or Rhythm Set settings to the user memory and System settings to the system memory. By loading sound data from memory card or Wave Expansion Boards to user memory, you can add many different sounds to your performance.

Type (Data Type)

Specify the type of data to be transmitted.

ALL: Performance, Patch, and Rhythm Set

PERFORM: Performance

PATCH: Patch

RHYTHM: Rhythm Set

SYSTEM: System (other than sequencer section)

Data type		Destination
	Source block

120