Roland XP-30 owner manual Rear Panel

Front and Rear Panel

■Rear Panel

Power Switch

Press to turn the power on/off. → p. 26

AC Inlet

Connect the AC power cable (included) to this inlet. → p. 24

*With units rated for 117V operation, the AC cable is already connected to the unit.

CONTROL PEDAL Jack

You can connect optional expression pedals to these jacks. By assigning a desired function to a pedal, you can use it to select or modify sound or perform various other control. You can also connect optional pedal switches to sustain sound.

→p. 24, 110

MEMORY CARD Slot

An optional memory card (SmartMedia) can be inserted here.

→p. 115

MIDI Connectors (IN, OUT, THRU)

These connectors can be connected to other MIDI devices to receive and transmit MIDI messages. → p. 24, 119, 132

COMPUTER Switch

Set this switch depending on the type of computer connected to Computer connector, or the software you are using. Turn the power off before changing the setting of this switch. If you wish to use the MIDI connectors, set this switch to MIDI.

→p. 134

COMPUTER Connector

A special Computer cable (sold separately) can be connected here. The type of cable required will depend on your computer. When the Computer switch located at the left is set to MIDI, this connector cannot be used. → p. 134

HOLD PEDAL Jack

An optional pedal switch can be connected to this jack for use as a hold pedal. → p. 24, 110

OUTPUT Jacks (L (MONO), R)

These jacks output the audio signal to the connected mixer/ amplifier system in stereo. For mono output, use the L jack.

→p. 24

PHONES Jack

An optional set of headphones can be connected to this jack.

→p. 24

14