Roland XP-30 owner manual Creating Your Own Sounds Patch EFX OUT Patch EFX Output, Patch Chorus

Chapter 3. Creating Your Own Sounds

PATCH EFX OUT (Patch EFX Output)

These parameters specify the output for the Tone for which EFX was selected in Output Assign.

*For Tones which have an Output Assign setting of MIX, the settings of this display will be ignored.

Mix Out (EFX Output Level)

Adjust the volume level of the original sound and the Multi- Effects sound.

Chorus (Chorus Send Level)

Adjust the amount of Chorus for the sound that passes through Multi-Effects.

Reverb (Reverb Send Level)

Adjust the amount of Reverb for the sound that passes through Multi-Effects.

PATCH EFX CTRL (Patch EFX Control)

Use this setting when you wish to use a specific controller to control an EFX parameter. The EFX parameters available for control will depend on the selected EFX type. For details refer to “Multi-Effects Types (EFX Parameter)” (p. 93). The upper line of the display will show the EFX parameters that can be controlled. For each EFX parameter, you can specify the EFX Control Source and the EFX Control Depth.

PATCH CHORUS

These parameters control the Chorus effect of the Patch.

Rate (Chorus Rate)

Adjust the speed of modulation for the Chorus effect.

Depth (Chorus Depth)

Adjust the depth of modulation for the Chorus effect.

Delay (Chorus Pre Delay)

Adjust the time delay after the original sound begins until the Chorus effect begins to apply. Higher settings result in a more spacious effect.

Fbk (Chorus Feedback Level)

Adjust the amount of sound from the Chorus output that is returned (fed back) to the Chorus. Higher settings result in a more intense effect.

Level (Chorus Level)

Adjust the volume of the Chorus effect.

Out (Chorus Output Assign)

Select the way in which the Chorus and Reverb are connected.

MIX: The Chorus sound and the Reverb sound are mixed.

EFX Control Source 1, 2

The following MIDI controllers can be used. If you wish to use a controller that will apply to all Patches, or a controller that cannot be directly specified here, select SYS-CTRL1 or SYS-CTRL2, and then select the controller using the Control 1/2 parameter (SYSTEM/CONTROL/SYS-CTRL ASSIGN).

Chorus input

Reverb input

Reverb

OUTPUT

Chorus

OFF:	controller not used
SYS-CTRL1:	System controller (control 1)
SYS-CTRL2:	System controller (control 2)

MODULATION: Modulation (MIDI controller number 1)

BREATH:	Breath (MIDI controller number 2)
FOOT:	Foot (MIDI controller number 4)
VOLUME:	Volume (MIDI controller number 7)
PAN:	Pan (MIDI controller number 10)
EXPRESSION:	Expression (MIDI controller number 11)
BENDER:	Pitch bend

AFTERTOUCH: Aftertouch

EFX Control Depth 1, 2

Adjust the amount of change that will occur in response to controller movements. Higher settings will result in greater change. Negative (-) settings will reverse the direction of change.

REV:Apply reverb to the chorus sound.

Chorus
input
Chorus	Reverb	OUTPUT

Reverb input

M+R: Mix the chorus sound to which reverb is not applied and the chorus sound to which reverb is applied.

Reverb
input	Reverb	OUTPUT
Chorus

Chorus input

72