Roland XP-30 owner manual Parameter List Control Group p, Wave Group p, LFO Group p, 148

Parameter List

CONTROL Group (p. 73)

Display	Parameter		Value
KEY MODE&BENDER	Assign	Key assign mode	POLY, SOLO
	Legato	Solo legato switch	OFF, ON
	Bend Range	Bend range down	-48–0 semitone
		Bend range up	0–+12 semitone
PORTAMENTO	Sw	Portamento switch	OFF, ON
	Time	Portamento time	0–127
	Mode	Portamento mode	NORMAL, LEGATO
	Type	Portamento type	RATE, TIME
	Start	Portamento start pitch	PITCH, NOTE
RxSWITCH	Volume	Receive volume switch	OFF, ON	T
	Pan	Receive pan control switch	OFF, CONT, KEY-ON	T
	Pitch Bend	Receive pitch bend switch	OFF, ON	T
DAMPER	Hold-1 RxSwitch	Receive hold-1 switch	OFF, ON	T
	Redamper	Redamper switch	OFF, ON	T
PEAK & HOLD	EfxCtrl	EFX control peak/hold	OFF, HOLD, PEAK
	Ctrl 1	Control1 peak/hold	OFF, HOLD, PEAK
	Ctrl 2	Control2 peak/hold	OFF, HOLD, PEAK
	Ctrl 3	Control3 peak/hold	OFF, HOLD, PEAK
CONTROL SOURCE	Control 2	Control source 2	(*1)
	Control 3	Control source 3	(*1)
CONTROL 1	Destination	Control destination 1–4	(*2)	T
	Depth	Control depth 1–4	-63–+63	T
CONTROL 2	Destination	Control destination 1–4	(*2)	T
	Depth	Control depth 1–4	-63–+63	T
CONTROL 3	Destination	Control destination 1–4	(*2)	T
	Depth	Control depth 1–4	-63–+63	T

*1: OFF, SYS-CTRL1, SYS-CTRL2, MODULATION, BREATH, FOOT, VOLUME, PAN, EXPRESSION, PITCH BEND, AFTERTOUCH, LFO1, LFO2, VELOCITY, KEYFOLLOW, PLAYMATE

*2: OFF, PCH, CUT, RES, LEV, PAN, MIX, CHO, REV, PL1, PL2, FL1, FL2, AL1, AL2, pL1, pL2, L1R, L2R

WAVE Group (p. 76)

Display	Parameter		Value
WAVE	Group	Wave group	INT-A, INT-B, XP-A, XP-B, XP-C, XP-D, XP-E	T
	Number	Wave number	001–255	T
	Gain	Wave gain	-6, 0, +6, +12 dB	T
	Switch	Tone switch	OFF, ON	T
FXM	Switch	Frequency cross modulation switch	OFF, ON	T
	Color	Frequency cross modulation color	1–4	T
	Depth	Frequency cross modulation depth	1–16	T
TONE DELAY	Mode	Tone delay mode	(*1)	T
	Time	Tone delay time	0–127/0–880/0–5000 (*2)	T

*1: NORMAL, HOLD, PLAYMATE, CLOCK-SYNC, KEY-OFF-N, KEY-OFF-D, TEMPO-SYNC

*2: When the Tone Delay Mode parameter is set to “CLOCK-SYNC” this is set as a Note value.

LFO Group (p. 78)

Display	Parameter		Value
LFO1	Form	LFO form	TRI, SIN, SAW, SQR, TRP, S&H, RND, CHS	T
	Key Sync	LFO key Sync	OFF, ON	T
	Rate	LFO rate	0–127, 0–880 (*1)	T
	ExtSync	LFO external sync	OFF, CLOCK	T
	Mode	LFO fade mode	ON-IN, ON-OUT, OFF-IN, OFF-OUT	T
	Delay	LFO delay time	0–127	T
	Fade	LFO fade time	0–127	T
	Offset	LFO offset	-100, -50, 0, +50, +100	T
LFO2	(*2)			T
LFO DEPTH1:2	Pitch	Pitch LFO depth 1, 2	-63–+63	T
	TVF	TVF LFO depth 1, 2	-63–+63	T
	TVA	TVA LFO depth 1, 2	-63–+63	T
	Pan	Pan LFO depth 1, 2	-63–+63	T

*1: When the LFO External Sync parameter is set to “CLOCK” this is set as a Note value.

*2: Same as LFO1.

148