Roland XP-30 owner manual Controller Settings

Quick Reference of Procedures

Selecting Performances Using the Digit Hold Function

1.Press [SHIFT] + [ENTER] (turn on the Digit Hold function).

2.Use the numeric keys to specify the number of the one’s place.

*To turn off the Digit Hold function, press [SHIFT] + [ENTER] once again.

Modifying a Performance (basic procedure)

1.Make the [EDIT] indicator light.

2.Use the function buttons to select the display group.

3.Use []/[] to select the desired display page.

4.Turn off the [EDIT] indicator.

5.Use [PART] (function button) to select the Tone.

6.Use []/[] to select a parameter.

7.Use the VALUE dial, [INC]/[DEC], or the numeric keys to modify the value.

*If you wish to move to a different parameter group, turn on the [EDIT] indicator.

Adjusting the Volume of a Part

1.Turn on the [EDIT] indicator.

2.Press [PART] (function button).

3.Use []/[] to select the PART SETTING display.

4.Set the Level parameter.

Adjusting the Pan Position of a Part

1.Turn on the [EDIT] indicator.

2.Press [PART] (function button).

3.Use []/[] to select the PART SETTING display.

4.Set the Pan parameter.

Modifying a Rhythm Set (basic procedure)

1.Press [PERFORM] + [PATCH].

2.Use []/[] to select Part 10.

3.Use the VALUE dial, [INC]/[DEC], or the numeric keys to select a Rhythm Set.

4.Make the [EDIT] indicator light.

5.Use the function buttons to select the parameter group.

6.Use []/[] to select the desired display page.

7.Use []/[] to select a parameter.

8.Use the keyboard to select a rhythm instrument.

9.Use the VALUE dial, [INC]/[DEC], or the numeric keys to modify the value.

■Controller Settings

Changing the Range of the Pitch Bend Lever (for each Patch)

Bend Range parameter (PATCH/CONTROL/KEY

MODE&BENDER)

Selecting the MIDI Messages Controlled by the C1–C4 Sliders

Assign parameter (SYSTEM/CONTROL/C1–C4 ASSIGN)

Selecting the MIDI Messages Controlled by the CONTROL PEDAL

Polarity parameter (SYSTEM/CONTROL/CONTROL PEDAL)

Reversing the Polarity of CONTROL PEDAL (when using a pedal of another manufacturer whose polarity is reversed)

Polarity parameter (SYSTEM/CONTROL/CONTROL PEDAL)

Controlling Patch Parameters with a Slider or Pedal

You can specify up to three control sources (MIDI messages used for control). However control source 1 is fixed at “modulation”. For each control source, you can specify up to four control destinations (parameters to be controlled).

1.Specify the MIDI message to be controlled by each controller (C1–C4, CONTROL PEDAL) (see above).

2.Select the control source.

Control 2/3 parameter (PATCH/CONTROL/CONTROL SOURCE)

3.Specify the control destination (the parameter to be controlled).

Destination parameter (PATCH/CONTROL/CONTROL1–3)

*If you do not need to set different control sources for each Patch, set the Control 2/3 parameters (PPATCH/CONTROL/ CONTROL SOURCE) to “SYS-CTRL1” or “SYS-CTRL2,” and set the Control 1/2 parameters (SYSTEM/CONTROL/ SYS-CTRL ASSIGN) to the MIDI messages that you wish to use for control.

144