CCB01-010BTBase

USB Connection:

Note: The power supply must be ordered separately, if needed.

2.If you are connecting a CCB01-010BT Base, make sure the cables are secured in the wireways in the bottom of the cordless base and the base sits flat on a horizontal surface.

3.The scanner beeps.

4.Verify the scanner or cordless base operation by scanning a bar code from the Sample Symbols in the back of this manual.

The unit defaults to a USB PC Keyboard. Refer to page 2-3for other USB terminal settings.

For additional USB programming and technical information, refer to “USB Application Note,” available at www.honey- wellaidc.com.

Connecting with Keyboard Wedge

A scanner or cordless base can be connected between the keyboard and PC as a “keyboard wedge,” where the scanner provides data output that is similar to keyboard entries. The following is an example of a keyboard wedge connection:

1.Turn off power and disconnect the keyboard cable from the back of the terminal/computer.

2.Connect the appropriate interface cable to the device and to the terminal/computer.

Corded Voyager 1450g

Keyboard Wedge Connection:

1 - 2