Configuration

Figure 3-37 Camera PTZ Setup Screen

Note You will only be able to set up PTZ devices if the PTZ port is set to RS232 or RS485. You will not be able to use a modem if you are using the RS232 port for PTZ control.

5.Highlight the box in the Product column for the PTZ camera you wish to configure and press . A list of PTZ devices appears.

6.Select your camera from the list and press . You will need to connect the camera to the RS232 or RS485 connector on the back of the DVR following the camera manufacturer’s instructions.

Figure 3-38 PTZ Device List

7.You can assign IDs to each camera by highlighting the box under the ID heading and pressing . Change the number by highlighting it and using the Up and Down arrow buttons to increase and decrease the number. The PTZ ID number can be set from 0 to 256.

8.Highlight the Setup… box and press . The Port Setup window appears.

Document 900.0856 Rev 3.00

63

11/07