Configuration

Note For the Alarm-Out action, the alarm output and beep you select should be set to the Event mode in the Alarm-Out setup screen, Schedule tab (see Alarm-Out Screen, page 65).

14.Highlight the box under the Notify heading and press . You can toggle the entire list On and Off by highlighting Notification and pressing . You can toggle the individual items On and Off by highlighting that item and pressing .

Highlight OK and press to accept your changes.

Note For the Notify action, the notify item you select should be enabled in the Notification setup screen and the DVR should be registered in the RAS (Remote Administration System).

Figure 3-66 Motion Detection Actions 2 Screen

15.In the Actions 2 tab, highlight the desired box under the PTZ heading, and press

. A list of PTZ presets appears. Select the preset position for each PTZ camera, where you want PTZ cameras to move to whenever the DVR detects motion on the selected camera’s input.

16.Highlight the desired box under the Spot Monitor heading, and press . A list of SPOT monitors and cameras appears. Each SPOT monitor can be associated with a camera. The DVR will display the associated camera on the SPOT monitor whenever it detects motion on the selected camera.

17.You can save your Motion Detection changes by highlighting Save and pressing

. Selecting Cancel exits the screen without saving the changes.

82