Honeywell HWM-450, HWM-335 owner manual Manual Control Operation Models HWM-330 and HWM-331

QuickSteam_OM_04-25-06.qxd 4/25/06 4:53 PM Page 6

Manual Control Operation (Models HWM-330 and HWM-331)

P O W E R

CAUTION: DO NOT PLUG IN THE HUMIDIFIER WITH

WET HANDS AS AN ELECTRICAL SHOCK COULD

OCCUR.

•With the power switch in the OFF position, plug the filled humidifier into a polarized 120V outlet. DO NOT FORCE THE POLARIZED PLUG INTO THE OUTLET; it will only fit one way.

O U T P U T / M O I S T U R E C O N T R O L

•Set the Moisture Control knob to the desired position (Fig. 7). HIGH: For fast humidifying

LOW: For everyday moisture control

Fig. 7

Moisture Refill/

Control Clean

Knob

Power

Light Humidistat

(Illuminated)Knob

•Continuous Mode - Your unit will run continuously at your selected output level until you shut it off or it runs out of water.

A D V A N C E D M I S T ™ H U M I D I S T A T

The Advanced Mist™ Humidistat allows you to adjust and select the humidity level to your personal preference. Your humidifier will turn on and off throughout the day and night to maintain the desired humidity level you have selected.

H O W T O S E T T H E H U M I D I S T A T

First, turn the Humidifier on and select your moisture/output level. Set the Advanced Mist™ Humidistat on HIGH by turning the knob clockwise to the end (Fig. 7).

•Let the humidifier run on high for a least one hour or until your room has reached a comfortable humidity level.

•At this point, slowly turn your Humidistat knob counter-clockwise (Fig. 8).

Fig. 8

until the humidifier shuts off

•Now that your Humidistat knob is set, the humidifier will automatically turn back on when your room drops below your comfort setting and will automatically turn off again when the setting is reached.

NOTE: If the humidifier will not start or restart when you select a moisture level, the Advanced Mist™

Humidistat may be set too low. Turn the dial clockwise to the end (Fig. 7).

R E F I L L / C L E A N H U M I D I F I E R

•	When the Refill/Clean indicator light is illuminated it implies your unit	Fig. 9
	is out of water or you need to clean your humidifier (Fig. 9).
		Refill/Clean Light
•	Check your water level. If your Tank is empty, turn your Power knob	(Illuminated)
	to the OFF position, remove the Tank and refill it as described in the
	FILLING section.
•	If your water level is full, this implies it’s time to clean your
	humidifier. Please turn off and unplug the unit and refer to the
	CLEANING section.

NOTE: Your unit’s performance will decrease if you do not clean your heating plate. Your unit may continuously shut off and output will decrease.

NOTE: Do not turn on the unit until the tank is refilled and reinstalled.

6