Honeywell HWM-450 Manual Control Operation HWM-331, EasySet Control Operation Model HWM-335

Fig. 10

QuickSteam_OM_04-25-06.qxd 4/25/06 4:53 PM Page 7

Manual Control Operation (HWM-331)

NOTE: This product is equipped with a Vapor Mist Sensor Badge

(Fig 10). When the Vapor Mist Sensor Badge located on the medicine cup, turns from grey to blue warm moisture

is being emitted from the humidifier. Do not touch the medicine cup or warm moisture outlet grille unless the unit has been turned off and the Vapor Mist Sensor Badge has turned back to grey.

EasySet™ Control Operation (Model HWM-335)

P O W E R

CAUTION: DO NOT PLUG IN THE HUMIDIFIER WITH

WET HANDS AS AN ELECTRICAL SHOCK COULD

OCCUR.

•With the power OFF, plug the filled humidifier into a polarized 120V outlet. DO NOT FORCE THE POLARIZED PLUG INTO THE OUTLET; it will only fit one way.

S T E P 1 : P O W E R

•Press the Power button to start the humidifier. Your humidifier will automatically start on High power, continuous run (Fig. 11).

•To turn your humidifier OFF simply press the Power button again.

S T E P 2 : O U T P U T / M O I S T U R E C O N T R O L

Your unit has three output/moisture levels:

HIGH: For fast humidifying

MED: For everyday moisture control

LOW: For minimum operation (ideal for nighttime use)

•Push the Up button (+) to increase output level and push the Down button (-) to decrease output level. The LED's will illuminate to reflect which level you have selected (Fig. 12).

•Continuous Mode: Your unit will run continuously at your selected output level until you shut it off or it runs out of water.

S T E P 3 : S E T H U M I D I T Y

•Set your desired humidity anywhere between 35% and 55%.

•Push the Up button (+) to increase desired humidity and push the Down button (-) to decrease desired humidity. The LED's will illuminate to reflect which desired humidity level you have selected (Fig. 13).

For example: If you set your humidity at 40%, the 35% and 40% LED’s will be illuminated.

•Once you have set your desired humidity, the unit will operate under this desired setting until the unit is turned off.

Fig. 11

Humidistat	Moisture
	Control
Control
Refill/
Clean
Light
Power	Reset
Button	Button
(On/Off)

Fig. 12

Fig. 13

•When the desired room humidity has been reached the unit will automatically shut off. (The humidity LED's will remain illuminated.)

•Your unit will turn back on when your room decreases beyond your set level.

NOTE: Your room humidity can often fluctuate. It is normal for your unit to turn itself on and off throughout the day as it is monitoring your changing environment.

To go back to Continuous Mode, turn your unit off and then back on and select your desired output setting (see Step 2).

7