PasswordStart > Settings > Control Panel > Password

Use this panel to set MX3Plus user access to control panels and power up password properties. Important: This password must be entered before performing a cold boot or cold reset.

If entering a power-on or screen saver password does not allow you to disable this password protection or perform a cold boot, contact Customer Support.

Factory Default Settings

Password

Blank

 

 

Enter password at Power On

Disabled

 

 

Enter password at Remote Desktop Screen Saver

Disabled

 

 

•The password and password settings are saved during a warm boot and a cold boot.

•The screensaver password affects the Remote Desktop screensaver only.

•After a password is assigned and saved, each time a Settings > Control Panel option is selected, the user will be required to enter the password before the Control Panel will open.

•The screensaver password is the same as the power-on password. They are not set independently.

•A screensaver password cannot be created without first enabling the “Enable password protection at power-on” checkbox.

•The screensaver password is not automatically enabled when the “power-on” checkbox is enabled.

Enter the password in the Password text box, then press Tab and type the password again to confirm it. Enable the power-on checkbox and, if desired, the screensaver checkbox.

A changed/saved password is in effect immediately.

4-107