USB Client Cable

Connect from USB-H serial port to USB Type B Male receptacle on a USB hub, camera, etc.

Mobile Device End

Goes To

USB Type B Plug End

 

 

 

1 Not Used

 

 

 

 

 

2 Not Used

 

 

 

 

 

3 D + (Green Wire)

 

3

 

 

 

4 Not Used

 

 

 

 

 

5 Ground (Black Wire)

 

4

 

 

 

6 Not Used

 

 

 

 

 

7 D - (White Wire)

 

2

 

 

 

8 Not Used

 

 

 

 

 

9 Power

 

1

 

 

 

Tethered Scanners

Do not connect a tethered scanner cable to a MX3Plus USB-C or USB-H labeled endcap port. These ports cannot power a tethered scanner.

Tethered scanners connect to RS-232 labeled ports on the endcap and can connect to the RS232 port on a powered cradle.

The MX3Plus Scan buttons have no effect on tethered bar code scanners (connected to a serial port). Tethered scanners read bar code scans only when the trigger on the tethered scanner is pressed. The tethered scanner requires power on pin 9 of the mobile device’s serial port.

To set the MX3Plus to use a tethered scanner, select Start > Settings > Control Panel > Scanner > COM1 (or 2 or 3).

Tap the “Power on Pin 9 (+5V)” checkbox for the COM port selected. The COM port that accepts the scanner data can be configured for data rate, parity, stop bits and data bits.

2-9