BUILDING NETWORK ADAPTER BNA-1C/2CS/2DN
2.Wait till the heartbeat LED starts flashing RED, then press the Mode Button.
3.The heartbeat flashing immediately stops and the LED is permanently on. The operating modes are displayed using the LAN status LEDs Lnk, Tx, Rx. The Normal Mode is represented via the Lnk LED.
4.Now push the Mode Button again and the Tx LED will also be switched on. Two LEDs on means Stay in Bootloader Mode is selected.
5.To accept one of the modes, push the Mode Button again and hold it for about 1 second. The BNA Bootloader feedback that the mode has been accepted is indicated with all Mode LEDs and the heartbeat LED flashing four times.
If there is no need to change the mode after the mode button has been pressed, then just stop pressing the mode button. The BNA device will continue with its normal work after a few seconds.
26 |
