BUILDING NETWORK ADAPTER BNA-1C/2CS/2DN
If this is the very first run of the device, then the Copyright notice is followed by the query for the root user password. At the Old password: prompt just hit the
Once a password has been defined the BNA prints the information User 'root' logged in. for all future startups.
The root user is the administration user with unlimited access rights. The root user will be logged in automatically without any login procedure when connecting to the BNA device via the serial link (RS232). Any connection to the BNA via LAN is password protected!
If the device already contains an application firmware, then it is necessary to put the device into the Stay in Bootloader Mode prior to the setup activity (refer to chapter 6.3 Switching the Operating Mode on Page 25 how this can be done).
To prepare the BNA device to operate on the LAN and to load the application firmware into the device, the following mandatory commands must be executed in the order they are listed (for a detailed command description, refer to chapter
6.5 Command Description on Page 31):
np | Basic network parameters |
| Definition of IP address, network mask |
| and default gateway. These definitions |
| are required to allow the BNA device to |
| operate on the LAN. |
|
|
29 |
