21 | SMARTBOX Installation |
|
|
|
|
To connect the SMARTBOX™ Controller:
1.Mount SMARTBOX™ Controller to the wall per instructions on pages
2.Place battery enclosure in a dry,
3.Install and level turbine. See the HONEYWELL™ WindTurbine Owner’s Manual.
SHOCK HAZARD
Always lock the blades before working with the turbine. Unlocked blades can produce voltages on the DC output. Failure to follow this warning may result in death, personal injury or property damage.
4. Attach the electrical conduit. Follow local electrical codes for compliance.
WARRANTY VOID WARNING
DO NOT drill holes for conduit in SMARTBOX™ Controller. Use
FIRE AND SHOCK HAZARD
The NEC code stipulates that AC, DC and control wiring MUST NOT cross within any enclosure. Failure to follow this warning may result in death, personal injury or property damage.
5.Run wiring between turbine and SMARTBOX™ Controller. Reference the turbine wiring diagram on page 12; Figure 2.4.
6.Run turbine control wiring. Reference the turbine control wiring diagram on page 19; Figure 2.12.
7.Run battery wiring. Reference the battery wiring diagram on page 15; Figure 2.7.
8.Run AC wiring. Reference AC wiring diagrams on pages
9.Follow commissioning for start up procedure. Page 24.
REVERSE POLARITY DAMAGE
Before making the final DC connection or closing the DC breaker or disconnect, check cable polarity at both the battery and the SmartBox. Positive (+) must be connected to positive (+).
SMARTBOX™ Controller for HONEYWELL™ Wind Turbine WT6500 Owner’s Manual - Rev14
