Safety Instructions | Honeywell WT6500 guide

IV	Safety Instructions

The SMARTBOX™ Controller for the HONEYWELL™ Wind Turbine WT6500 is manufactured by WindTronics Inc. Please contact WindTronics Inc. at:

621 Sprucewood Avenue

Windsor, Ontario

N9C 0B3

877-946-3898

The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell International Inc. makes no representations or warranties with respect to this product.

SMARTBOX™ Controller for HONEYWELL™ Wind Turbine WT6500 Owner’s Manual - Rev14

Image 4

Honeywell WT6500 owner manual Safety Instructions

Contents

Smartbox Controller Safety Instructions Safety IconsImportant Safety Instructions General Safety Instructions Battery Safety Information Limitations on USE Safety Instructions Safety Instructions Table of Contents Commisioning Introduction For Information On See Major System Components Smartbox ControllerParts Inspection Battery Overview Battery TypesNot to be used Minimum to be used AC Load Detail and Selection Battery SelectionAmp-hour Ratings Recommended Appliances Not Recommended Introduction Installation Smartbox Controller System Diagrams Turbine Block Diagram Mounting Smartbox Controller DiagramRisk of Fire or Explosion Equipment Damage Minimum Clearance for Proper MountingEXPLOSION/CORROSION Damage Wiring GroundingShock Hazard Shock Hazard and Fire Hazard Wiring Diagram Turbine to Turbine Wiring and Distances Turbine Current Rating and Wiring Turbine Over-current Protection Reverse Polarity Damage Battery Wiring Battery Connection Location Battery Over-current Protection Shock or Fire Hazard AC Input Wiring AC Output Wiring Turbine Smartbox Controller AC Output Over-current Protection Control Wiring Junction BOX Battery Setup Connecting the Smartbox ControllerEnclosure Internal Wiring Battery Setup Chart To connect the Smartbox Controller Warranty Void WarningFire and Shock Hazard Smartbox Installation Commissioning For Information on See Commissioning Process Set the battery type Flooded Commissioning ProcessCheck all connections for polarity Display Description Shows if a turbine voltage was found Press Enter to start the turbine Commissioning Operation Introduction Turbine Operating StatesStarting/Stopping Turbine Viewing Operating Status Controller Energy Consumption States Turbine Operating States System Protection Turbine User Stop StateCool Down Over Wind Speed Non Grid-Tie SmartBox Fault Specifications System FaultsFault Description State Required for Fault Smartbox Controller Front Panel Navigation ButtonsSystem Menu and Navigation Operations Menu Technician Menu View Data Menu Battery Setup Menu Operation Specifications Non Grid-Tie Smart Box Electrical Specifications InputCharge Environment WindTronics