| |
E |
|
D | C |
Positioning belt and agitator
Slip agitator through new belt (with let- tering toward outside of cleaner) and position belt in belt guide (C). Push end of belt into opening in cleaner body.
Reposition agitator making sure to align flat sides of projection (D) on belt end of agitator with flat sides of slot (E) in cleaner body.
Replacing bottom plate
Place the three tabs on bottom plate into slots in front of cleaner body. Snap bot- tom plate into place over agitator.
|
Removing hood
Remove hood by turning cleaner over and removing nozzle control knob on front of hood, grasp knob and pull up.
|
Place handle in operating position and turn cleaner over.
Insert end of flat screwdriver into one of the four slots beside an arrow on bottom of cleaner.
For slots nearest the rear wheels, push handle of screwdriver toward cleaner handle; for remaining two slots, pry out- ward to release latches.
|
Turn cleaner over and lift off hood.
|
F |
Positioning belt onto pulley
Stretch new belt onto motor pulley (F).
Extra effort may be required to stretch new belt onto pulley.
Turn agitator, making sure the belt is not pinched between agitator and cleaner body. The belt must rotate freely inside the belt guide.
If agitator does not turn, remove bottom plate and reposition belt in belt guide.
|
Reposition hood
Replace hood and nozzle control knob.
The agitator |
|
When to replace
Disconnect cleaner from electrical outlet.
When agitator brushes are worn, the agitator should be replaced.
To check condition of brushes, move edge of card across bottom plate while turning agitator.
To maintain cleaning effectiveness, replace agitator if brushes do not touch card.
12
