II. Installation and Operating Instructions
WARNING
1.This icemaker must be installed in accordance with applicable national, state, and local regulations.
2.CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are securely in place after installation. Make sure that none have fallen into the storage bin.
A.Checks Before Installation
•Visually inspect the exterior of the shipping container and immediately report any damage to the carrier. Upon opening the container, any concealed damage should also be immediately reported to the carrier.
•Remove the shipping carton, tape, and packing material. If any are left in the icemaker, it will not work properly.
•Remove the panels to prevent damage when installing the icemaker. See "II.B. How to Remove Panels."
•Remove the package containing the accessories.
•Remove the protective plastic film from the panels. If the icemaker is exposed to the sun or to heat, remove the film after the icemaker cools.
•Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the fan blade (if applicable) turns freely.
•Check that the compressor is snug on all mounting pads.
•See the nameplate on the rear panel, and check that your voltage supplied corresponds with the voltage specified on the nameplate.
•This icemaker can be installed on a storage bin 30" wide or wider with a depth of 40" or greater.
•On remote
B. How to Remove Panels
See Fig. 1 |
|
• Front Panel: Remove the 2 screws. Lift | Side Panel (L) |
up and towards you. |
|
• Top Panel: Remove the 2 screws, and lift off.
• Side Panel (R): Remove the screw. Slide forward slightly and lift off.
• Side Panel (L): Remove the 6 screws, and lift off.
Top Panel
Top Insulation 
Rear Panel
• Rear Panel: Remove the 6 screws, and | Insulation | |
lift off. | ||
• Insulation Panel: Remove the | Panel | |
Front Panel | ||
thumbscrew. Lift up slightly and pull | ||
| ||
towards you. |
|
Side Panel (R)
Fig. 1
11
