Hoshizaki KMH-2000SWH/3, KMH-2000SRH/3 5Install the bin control thermostat as follows

Models: KMH-2000SWH/3 KMH-2000SRH/3

1 35
Download 35 pages 58.26 Kb
Page 13
Image 13
5)Install the bin control thermostat as follows:
Fig. 4
Thermostat Bulb Attachment (plastic)
Thermostat Bracket (plastic)
Silicone Hose
Thermostat Extension
Bracket (stainless) "Z" Bracket (plastic)

5)Install the bin control thermostat as follows:

a.Remove the baffle from the bin (if applicable).

b.Remove the tie securing the bin control thermostat assembly. Remove the 2 thumbscrews and the "Z" bracket. See Fig. 3.

c.Remove the bin control thermostat assembly from the shipping hook. Lower the thermostat extension bracket (stainless) with the thermostat bulb attachment and thermostat bulb through the hole located at the bottom of the icemaker. Next, lower the thermostat bracket (plastic) through the hole.

d.Slide the left side of the upper part of the assembly towards you and make sure it is hooked on the wall. Make sure the left side and bottom of the assembly are flush against the wall and base panel.

e.Secure the assembly in place with the thumbscrews (unless you are installing an upper unit).

f.Insert the plug into the receptacle on the assembly until it locks into place.

Note: Icemaker will not run if the plug is not in the receptacle.

Thermostat Bulb

 

 

 

 

 

Attachment (plastic)

Tie

 

 

 

and Thermostat Bulb

Shipping Hook

 

 

 

 

 

 

 

 

 

Plug

Hook

 

 

 

 

 

 

 

 

 

 

Bushing

 

 

 

Bin Control

 

 

 

 

Thermostat

 

 

 

 

Assembly

 

 

 

 

 

Receptacle

Thumbscrews

 

 

 

 

 

 

Hole

 

Thermostat Bracket

 

Thumbscrews

 

(plastic)

 

 

 

 

 

 

"Z" Bracket

Thermostat Extension

Fig. 3

 

Bracket (stainless)

 

 

 

g. Remove the 2 screws securing the thermostat bulb attachment (plastic) to the thermostat extension bracket (stainless). See Fig. 4. Use the 2 screws to attach the "Z" bracket (plastic) to the thermostat extension bracket (stainless).

h. Use the two 4×10 stainless steel screws in the accessory bag to attach the thermostat bulb attachment (with attached thermostat bulb) to the "Z" bracket.

i. Remove the 2 screws from the lower part of the thermostat bracket (plastic)

and use them to attach the thermostat extension bracket (stainless) to the thermostat bracket (plastic).

j. Make sure the silicone hose is in place to prevent ice from striking the capillary tube.

13

Page 13
Image 13
Hoshizaki KMH-2000SWH/3, KMH-2000SRH/3 instruction manual 5Install the bin control thermostat as follows