Remove the speaker:

1.Disconnect the speaker cable (1) from the system board.

2.Remove the Phillips PM2.0×4.0 screw (2) and the Phillips PM2.0×6.0 screw (3) that secure the speaker to the base enclosure.

3.Remove the speaker (4) from the base enclosure.

Reverse this procedure to install the speaker.

Bluetooth module cable

NOTE: The Bluetooth module cable is included in the Cable Kit, spare part number 598766-001.

Before removing the Bluetooth module cable, follow these steps:

1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the computer.

3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.

4.Remove the battery (see Battery on page 44), and then remove the following components:

a.Memory module compartment cover (see Expansion memory module on page 48)

b.Wireless module compartment cover (see WLAN module on page 53)

c.Switch cover and keyboard (see Switch cover and keyboard on page 65)

Component replacement procedures 87