7.Rotate the drive cage all the way up. Figure 7-30Rotating the Drive Cage Up

8.Slide the drive into the drive bay (1) until the two screw holes on the left side of the drive line up with the two screw holes on the left side of the drive cage. Secure drive by fastening two retainer screws through the holes in the left side of the drive cage into the corresponding holes in the left side of the drive (2).

Figure 7-31Installing a 3.5-inch Device (Diskette Drive Shown)

NOTE: The drive cage screw holes for each type of drive are labeled “CR” for media card reader or “FDD” for diskette drive.

Extra retainer screws are provided on the front of the chassis under the hard drive cage. The M3 metric retainer screws for diskette drives or media card readers are black.

Drives 111

Page 121
Image 121
HP 3080 manual