9.Push in the latch holding the drive cage upright (1) and lower the drive cage all the way down

(2).

Figure 7-32Lowering the Drive Cage

10.Connect the appropriate drive cables:

a.If installing a diskette drive (available on some models only), connect the power and data cables to the rear of the drive and connect the other end of the data cable to the connector on the system board.

b.If installing a media card reader, connect the USB cable from the media card reader to the USB connector on the system board.

11.Replace the front bezel and access panel.

12.Reconnect the power cord and turn on the computer.

13.Lock any security devices that were disengaged when the access panel was removed.

112 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis

Page 122
Image 122
HP 3080 manual