HP 3080 manual Table D-4Specifications HP Pro 3010 Small Form Factor, Heat Dissipation

Table D-3Specifications – HP Pro 3000/3080 Small Form Factor (continued)

Power Output	300 W	300 W
Rated Input Current (maximum)1	8A @ 100 VAC	4A @ 200 VAC

1This system utilizes a passive power factor corrected power supply. The power factor correction is present in the 230V operating mode only. This allows the system to pass the CE mark requirements for use in the countries of the European Union. This supply requires the use of an input voltage range select switch.

Table D-4Specifications – HP Pro 3010 Small Form Factor

Desktop Dimensions
Height	3.98 in	101 mm
Width	13.35 in	339 mm
Depth	15.24 in	387 mm
Approximate Weight	14.95 lb	6.78 kg
Temperature Range
Operating	50° to 95°F	10° to 35°C
Nonoperating	-22° to 140°F	-30° to 60°C
Relative Humidity (noncondensing)
Operating	10-90%	10-90%
Nonoperating (38.7°C max wet bulb)	5-95%	5-95%
Maximum Altitude (unpressurized)
Operating	10,000 ft	3048 m
Nonoperating	30,000 ft	9144 m

NOTE: Operating temperature is derated 1.0° C per 300 m (1000 ft) to 3000 m (10,000 ft) above sea level; no direct sustained sunlight. Maximum rate of change is 10° C/Hr. The upper limit may be limited by the type and number of options installed.

Heat Dissipation
Maximum	1575 BTU/hr	397 kg-cal/hr
Typical (idle)	307 BTU/hr	77 kg-cal/hr
Power Supply	115V	230V
Operating Voltage Range	90-132 VAC	180-264 VAC
Rated Voltage Range	100-127 VAC	200-240 VAC
Rated Line Frequency	50-60 Hz	50-60 Hz
Power Output	300 W	300 W
Rated Input Current (maximum)1	8A @ 100 VAC	4A @ 200 VAC

1This system utilizes a passive power factor corrected power supply. The power factor correction is present in the 230V operating mode only. This allows the system to pass the CE mark requirements for use in the countries of the European Union. This supply requires the use of an input voltage range select switch.

Small Form Factor 181