
*Only the diaphragm and spring are shown, though the entire magnetic valve ships in the kit. **The removal and replacement instructions for this component are not included in this document.
Technician repair required tools
The following tools are required for the removal and replacement instructions for each component included in the miscellaneous hardware kit:
•Flow meter
o
o Phillips screwdriver
o Water hose fitting wrench (included with your original MCS unit) o Counter hold wrench (included with your original MCS unit)
o 46 mm wrench (included in the miscellaneous hardware spare kit)
•Gasket
No tools are required for this procedure.
•Magnetic valve diaphragm and spring o
o Phillips screwdriver o 8 mm Allen wrench
Flow meter
The flow meter is a component of the water group located at the bottom interior of the MCS unit.
The following tools are required for installation:
•
•Phillips screwdriver
•Water hose fitting wrench (included with your original MCS unit)
•Counter hold wrench (included with your original MCS unit)
•
Removing the flow meter
Technician repair removal and replacement procedures 114