4.Using a T-25 Torx driver, secure the horizontal shipping bracket to the MCS unit by inserting four Torx screws.

Condensation pump and sensors

The condensation pump and sensors are components of the water group located at the bottom interior of the MCS unit.

The following tools are required for installation:

•T-25 Torx driver

•Phillips screwdriver

Removing the condensation pump and sensors

1.Power down the MCS unit ("Powering down the MCS unit" on page 24).

2.Remove the bottom fan unit ("Removing the bottom fan unit" on page 44).

3.Relocate the power inlet box ("Relocating the power inlet box" on page 93).

4.Remove the air sealing plate ("Removing the air sealing plate" on page 35).

Removal and replacement procedures 47