Operator display

The operator display is located on the front door of the MCS unit.

The following tools are required for installation:

8-mm socket

Small Flathead screwdriver

Removing the operator display

1.Power down the MCS unit ("Powering down the MCS unit" on page 24).

2.Open the front MCS door.

3.Using an 8 mm socket or wrench, remove the three nuts and external star washers securing the operator display rear cover to the back of the front MCS door.

4.Remove the operator display rear cover.

Removal and replacement procedures 88

Page 88
Image 88
HP 403349-003 manual Operator display, Removing the operator display