a.Disconnect the three large cables, starting from the left and moving to the right, by inserting a small flathead screwdriver in between the cable connection and the latch, and pulling the cable out from the connector.
b.Disconnect the three small cables, starting from the left and moving to the right, by pressing the small tab on the bottom of each small cable and pulling it out from the connector.
After you have disconnected all of the cables, the transfer switch chassis is free from restraint and can be removed from the water group controller chassis.
To replace this component, see "Replacing the AC transfer switch (on page 28)."
Replacing the AC transfer switch
1.Connect the green and yellow ground bonding wires to the water group controller.
Removal and replacement procedures 28