3 How to Install Accessories In Your PC

Installing Mass Storage Devices

5Connect the data and power cables to the rear of the device installed in the middle shelf. The connectors are shaped to go in one way only. If you are installing an IDE CD-ROM drive, connect the drive to the CD-ROM data cable. This data cable should be connected to the connector marked “CD-ROM” on the system board. If you are not sure which connector to use, refer to “Connecting an IDE Device to a Data Cable” on page 39.

Data cable

Power cable

6Install any other accessories before replacing the cover. Reconnect all cables and power cords.

WARNING Do not open the CD-ROM drive enclosure as there is a danger of electric shock, and the laser beam light could harm your eyes. Service should be carried out by qualified personnel.

To avoid discomfort from unexpected noise, always turn the volume down before connecting headphones or speakers.

Listening to loud sounds for prolonged periods may permanently damage your hearing.

Before putting on headphones, place them round your neck and turn the volume down. When you put on the headphones, slowly increase the volume until you find a comfortable listening level and leave the volume control in that position.

37