2.Use the Mylar tab to slide the assembly to the right (3) to disconnect it, and remove the assembly (4).

3.Remove the mounting bracket. On a hard drive:

a.Remove the 4 Phillips PM3.0×3.0 screws (1) that secure the hard drive bracket to the hard drive.

b.Using the Mylar tab, lift the bracket (2) away from the hard drive.

– or –

On a solid state drive:

a.Remove the 4 Phillips PM2.0×3.0 screws (1) that secure the solid-state drive bracket to the solid state drive.

b.Lift the solid-state drive module (2) to remove it.

Component replacement procedures 49