HP 5102 manual Select a parallel port mode ECP Enhanced Capabilities

System Configuration menu

NOTE: Some of the listed System Configuration options may not be supported by your computer.

Select	To do this
Language	Change the Computer Setup language.
Boot Options	● Set a Startup Menu delay (in seconds).
	● Enable/disable MultiBoot (enabled by default).
	● Set the Express Boot Popup delay in seconds.
	● Enable/disable Custom Logo (disabled by default).
	● Enable/disable Display Diagnostic URL (enabled by
	default).
	● Enable/disable CD-ROM boot (disabled by default).
	● Enable/disable SD Card boot (enabled by default).
	● Enable/disable floppy boot (enabled by default).
	● Enable/disable PXE Internal NIC boot (enabled by
	default).
	● Enable/Disable Unified Extensible Firmware Interface
	(UEFI) Boot Mode (disabled by default).
	● Set the Legacy Boot Order.
Device Configurations	● Enable/disable USB legacy support (enabled by default).
	When enabled, USB legacy support allows the
	following:
	◦	Use of a USB keyboard in Computer Setup even
		when a Windows® operating system is not running
	◦	Startup from bootable USB devices, including a hard
		drive, diskette drive, or optical drive connected by a
		USB port to the computer
	● Select a parallel port mode: ECP (Enhanced Capabilities
	Port), standard, bidirectional, or EPP (Enhanced Parallel
	Port).
	● Enable/disable fan always on while connected to an AC
	outlet (disabled by default).
	● Enable/disable Data Execution Prevention (select models
	only). When enabled, the processor can disable some
	virus code execution, which helps to improve computer
	security (disabled by default).
	● SATA (Serial Advanced Technology Attachment) device
	mode. The following options are available:
	◦	AHCI (Advanced Host Controller Interface)
	◦	IDE (Integrated Drive Electronics)
	◦	RAID (select models only)

Computer Setup in Windows Vista 89