c.Release the display panel/webcam cable (1) from the adhesive points (2) along the cable route on the back of the display panel.

d.Remove the display panel/wedcam cable.

8.If it is necessary to replace the display hinges, perform the following steps:

a.Remove the 2 Phillips PM2.0×3.0 screws (1) that secure each hinge to the display panel.

b.Remove the hinges (2).

9.If it is necessary to replace the microphone receiver, perform the following steps:

a. Release the microphone receiver from the clip (1) that secures it to the display enclosure.

Component replacement procedures 71

Page 79
Image 79
HP 5102 manual