802.1w Rapid Spanning Tree Protocol (RSTP) 802.1d Spanning Tree Protocol (STP)

Configuring Rapid Reconfiguration Spanning Tree (RSTP)

 

Transitioning from STP to RSTP

 

IEEE 802.1w RSTP is designed to be compatible with IEEE 802.1d STP. Even

 

if all the other devices in your network are using STP, you can enable RSTP

 

on your switch, and even using the default configuration values, your switch

 

will interoperate effectively with the STP devices. If any of the switch ports

 

are connected to switches or bridges on your network that do not support

 

RSTP, RSTP can still be used on this switch. RSTP automatically detects when

 

the switch ports are connected to non-RSTP devices in the spanning tree and

 

communicates with those devices using 802.1d STP BPDU packets.

 

Because RSTP is so much more efficient at establishing the network path,

 

though, that it is highly recommended that all your network devices be

 

updated to support RSTP. RSTP offers convergence times of less than one

 

second under optimal circumstances. To make the best use of RSTP and

 

achieve the fastest possible convergence times, though, there are some

 

changes that you should make to the RSTP default configuration. See “Opti­

 

mizing the RSTP Configuration” below, for more information on these

 

changes.

 

 

N o t e

Under some circumstances, it is possible for the rapid state transitions

 

employed by RSTP to result in an increase in the rates of frame duplication

 

and misordering in the switched LAN. In order to allow RSTP switches to

 

support applications and protocols that may be sensitive to frame duplication

 

and misordering, setting the Force Protocol Version parameter to STP-com­

 

patible allows RSTP to be operated with the rapid transitions disabled. The

 

value of this parameter applies to all ports on the switch. See information on

 

Force Version on page 13-12.

 

As indicated above, one of the benefits of RSTP is the implementation of a

 

 

larger range of port path costs, which accommodates higher network speeds.

 

New default values have also been implemented for the path costs associated

 

with the different network speeds. This can create some incompatibility

 

between devices running the older 802.1d STP and your switch running RSTP.

 

Please see the “Note on Path Cost” on page 13-15for more information on

 

adjusting to this incompatibility.

13-8