Troubleshooting the Test Set
Troubleshooting Procedures
Unratioed Power Test
We will examine six RF signal paths in the test set by observing their associated IF signals. Figure
Isolating Signal Path Problems
Figure 5-9 Diagram of IF Signal Path
Determining the RF component in the test set that is most likely the cause of a failure can be accomplished within four steps:
1.Run the
2.Record your test results in Table
3.Compare the results in Table
4.Investigate the most probable cause, based on the information in Table
Testing Signal Paths 1-4
1.Set the network analyzer to its factory default settings by pushing the
2.Set the source for step mode. Press the network analyzer keys:
INSTRUMENT STATE [PRESET]
STIMULUS [MENU]
{STEP}