HP 8517B manual Introduction, Rebuilt-Exchange Assemblies

7 HP 8517B Replaceable Parts

Introduction

Rebuilt-Exchange Assemblies

This section provides information about ordering replacement parts. Parts that can be replaced include major assemblies and chassis hardware, but not individual pieces of major assemblies. Table 7-1lists the major assembly reference designations and abbreviations used in the parts lists.

Rebuilt-exchange assemblies (R-E assemblies) cost less than new assemblies. They are available through the rebuilt-exchange program. Factory rebuilt (repaired and tested) assemblies meet all factory specifications required of a new assembly. They are available on an exchange (trade-in) basis only. Defective assemblies must be returned for credit. Figure 7-2illustrates the rebuilt-exchange procedure. The rest of the figures in this chapter provide parts information. If you have any questions, contact the HP Sales and Service office in your region.

Replaceable Parts List Use the illustrations in this chapter to help locate and identify HP 8517B replaceable parts. Each illustration is accompanied by a replaceable parts list that includes the following information:

•

•

•

Hewlett-Packard part number.

Part quantity as shown in the corresponding figure. (There may or may not be more of the same part located elsewhere in the instrument.) Part description, using the abbreviations found in Table 7-3.

NOTE	A typical manufacturer of the part is identified by a five-digit code (refer to
	the Manufacturers Code list in Table 7-2) and given only if a part is available
	from an alternate supplier (other than Hewlett-Packard).
	.

HP 8517B S-Parameter Test Set Manual 7-1