|
| Installing the A6828A Adapter |
|
| Specifying SCSI Parameters |
|
|
|
NOTE |
| If you set a particular maximum data transfer rate to the SCSI controller |
|
| (in this example, |
|
| rate is set to all the devices. |
|
| This happens because all the devices are connected to the same SCSI |
|
| bus, which is controlled by the SCSI controller. |
|
|
|
Step | 6. | After making the necessary changes, press the [ESC] key to exit the |
|
| Device Properties screen. This takes you back to the Adapter Properties |
|
| screen. |
Step | 7. | Press the [ESC] key to exit the Adapter Properties screen. |
|
| If you did not modify any of the SCSI parameters, then the Global |
|
| Properties screen appears. |
|
| However, if you modified any of the SCSI parameters, then the following |
|
| screen appears: |
|
| Adapter and/or device property changes have been made. |
|
| <Cancel Exit> |
|
| <Save changes then exit this menu> |
|
| <Discard changes then exit this menu> |
|
| Exit the Configuration Utility |
|
| Use the arrow keys to highlight your selection from the listed choices, |
|
| and then press the [ENTER] key to return to the Global Properties |
|
| screen. |
Step | 8. | Press the [ESC] key. This displays the following screen: |
|
| Are you sure you want to exit? |
|
| <Cancel Exit> |
|
| Save changes then exit this menu |
|
| Discard changes then exit this menu |
|
| <Exit the Configuration Utility> |
Use the arrow keys to highlight your selection from the listed choices, and then press the [ENTER] key to return to the EFI shell prompt.
Chapter 2 | 35 |