|
| Installing the A6828A Adapter |
|
| Installing the SCSI Driver |
|
| If you need to install one or more patches, go to step 2. |
Step | 2. | Install any necessary patches. |
Step | 3. | Follow the normal procedure to install the appropriate software bundle |
|
| for your |
Step | 4. Issue the swlist command to ensure that the necessary patches and the | |
|
| c8xx driver are present. |
Step | 5. Check to see if the c8xx driver is loaded in the kernel by doing one of the | |
|
| following two things: |
|
| • Use SAM, as follows: |
|
| 1. Select the “Kernel Configuration” icon. |
|
| 2. Select the “Drivers” icon. |
|
| 3. In the “Kernel Configuration” screen, check to see if the c8xx |
|
| driver is in the kernel. |
|
| • Issue the following command: |
|
| what /stand/vmunix grep scsi_c8xx.c |
|
| Check to see if the c8xx driver is listed. |
|
| If the driver is in the kernel, go to the section, “Configuring LUN 0” on |
|
| |
|
| If the driver is not in the kernel, go to step 6. |
Step | 6. Load the c8xx driver into the kernel through SAM: | |
|
| a. Select the “Kernel Configuration” icon. |
|
| b. Select the “Drivers” icon. |
|
| c. In the “Kernel Configuration” screen, follow the normal steps for |
|
| loading the driver into the kernel (and building a new kernel). |
|
|
|
NOTE |
| You need to reboot the system after completing these steps. |
|
| Once you have confirmed that the c8xx driver is in the kernel, go to |
|
| |
|
| section, “Configuring LUN 0” on page 52. |
Chapter 2 | 51 |