Installing the A6828A Adapter
Specifying SCSI Parameters
NOTE | As stated earlier, HP recommends you to always use the A6828A’s |
| maximum bus width (16 bits), unless you have Narrow |
| the bus and you are experiencing problems with the connection. |
|
|
If you decrease the maximum bus width value (16 bits) when the transfer rate (MT/sec) is set to 80 or 160, the following message is displayed:
Data Width cannot be set to narrow when MT/Sec is set to 80 or 160.
Press any key to continue.
|
| If you want to decrease the maximum bus width value of a particular |
|
| device, first set the transfer rate (MT/sec) to a lower value, and then |
|
| decrease the corresponding bus width value. |
Step | 6. | After making the necessary changes, press the [ESC] key to exit the |
|
| Device Properties screen. This takes you back to the Adapter Properties |
|
| screen. |
Step | 7. | Press the [ESC] key to exit the Adapter Properties screen. |
|
| If you did not modify any of the SCSI parameters, then the Global |
|
| Properties screen appears. |
|
| However, if you modified any of the SCSI parameters, then the following |
|
| screen appears: |
|
| Adapter and/or device property changes have been made. |
|
| <Cancel Exit> |
|
| <Save changes then exit this menu> |
|
| <Discard changes then exit this menu> |
|
| Exit the Configuration Utility |
|
| Use the arrow keys to highlight your selection from the listed choices, |
|
| and then press the [ENTER] key to return to the Global Properties |
|
| screen. |
Step | 8. | Press the [ESC] key. This displays the following screen: |
Chapter 2 | 47 |