Troubleshooting
Setting and Confirming SCSI Parameters
Setting SCSI ID
To set the initiator SCSI ID for an adapter using the SCSI command, use the following syntax:
SCSI init bus_number slot_number ID_number
where
bus_number Specifies the number of the bus on which the adapter is installed.
slot_number Specifies the number of the slot the adapter is in.
ID_num | Specifies the adapter’s SCSI ID number. |
For example, to set the SCSI ID for an adapter installed on bus 5 slot 2 to 6, issue the following command:
SCSI init 5 2 6
To display the result, issue the following command:
SCSI init 5 2
The output is as follows:
PCI device /5.2 = 6
Chapter 3 | 75 |