Removal Procedure

1.Unplug the ac adapter, if present, and remove the battery.

2.Remove the hard disk drive (see page 2-5).

3.Slide open the RAM cover about 3 mm, then lift off the cover.

Note

For an OmniBook 3000, if the RAM cover does not have a Mylar insulator on the inside, replace the cover with a new one. (Service note 3000-07.)

RAM Cover

Figure 2-5. Removing the RAM Cover

4.Release the two metal latches at the sides of the RAM board, so the free edge of the board pops up.

5.Pull the board out of the connector.

Note:

Some OmniBook 2100/3100s have only one RAM slot.

For an OmniBook 2100/3100 with a Pentium processor, no more than 32 MB is supported in this slot.

Figure 2-6. Removing a RAM Board

Reassembly Notes

∙Insert the RAM board into the connector at about a 30° angle until it is fully inserted. Then press down at both sides until both latches snap closed.

∙Place the RAM cover about 3 mm from its closed position, then slide it closed.

2-8

Removal and Replacement

HP OmniBook 2100/3000/3100