Removing Other Components

(HP Authorized Service Providers Only)

Required Equipment

∙Small Phillips screwdriver.

∙Pointed knife or probe (for display components).

∙5-mm hex driver (for bottom case components).

Removal Procedure

1.Unplug the ac adapter, if present, and remove the battery.

2.Remove the additional assemblies and follow the special steps indicated in the tables below.

Table 2-8. Removing Other Components (Authorized Providers)

Component

Bracket, Display

Cable, Icon/MB

Removal Procedures

See pages 2-16 and 2-18.

Plug-in module (page 2-4).

Display, but only until the icon PCA is removed (page 2-9).

Additional Steps

The display does not have to be removed.

Cable, Inverter/MB (12-inch display)

Cable, Inverter/MB (13-inch display)

Plug-in module (page 2-4). Display (page 2-9).

LCD module, but only until the bezel is removed (page 2-12).

Plug-in module (page 2-4). Display (page 2-9).

LCD module (page 2-12). Display case (page 2-18).

Reassembly Notes: The cable should protrude about 6 cm from the hinge.

Caution: Use compatible parts (page 2-12).

Reassembly Notes: The cable should protrude about 6 cm from the hinge.

Secure the inverter/MB cable to the case near the hinge area with a piece of Kapton tape.

Caution: Use compatible parts (page 2-12).

Cable, IR/Icon

Cable, LCD flex (12-inch display)

Plug-in module (page 2-4). Hard drive (page 2-5). Display (page 2-9). Keyboard (page 2-20). Top case (page 2-21).

Plug-in module (page 2-4). Display (page 2-9).

LCD module (page 2-12).

Remove the screws from the IR PCA and the speaker bracket.

Reassembly Notes: Make sure the cable is clamped by the bracket, and it routes through the bottom corner of the window opening.

Reassembly Notes: The notched end of the metal tube fits under the display bracket, and the tab on the side fits inside the hinge opening.

The upper grounding tab of the cable attaches around the hole for the left bezel screw in the display bracket.

Secure the LCD flex cable to the display bracket with a piece of conductive tape near the hinge.

Secure the LCD flex cable to the LCD module with a piece of Kapton tape next to the LCD connector.

Caution: Use compatible parts (page 2-12).

HP OmniBook 2100/3000/3100

Removal and Replacement 2-31