2.Remove these additional assemblies:

∙Floppy drive or other plug-in module (see page 2-4).

∙Hard drive (see page 2-5).

∙Display assembly (see page 2-9).

∙Keyboard (see page 2-20).

3.Remove the heatsink by doing the following:

∙Remove the three recessed screws from the heatsink.

Note: Do not remove the two middle screws from the heatsink. They hold a permanent part of the assembly.

∙Lift the front edge of the heatsink slightly and slide it toward the front of the computer until the four tabs along the back edge are free from the case.

∙Lift the right end of the heatsink and unplug the fan cable from the motherboard.

Heatsink (includes fan/cable),

Screw, M2×5mm

depends on the CPU type

Note: Smaller diameter

 

Do not remove

 

these two screws.

 

Fan cable connector

Speaker/TouchPad cable

CPU Thermal Kit (pad and spacer), depends on the CPU type

Figure 2-17. Removing the Heatsink

2-22 Removal and Replacement

HP OmniBook 2100/3000/3100