Icon PCA

Screw, M2.5× 5mm

Note: Two screws secure the cable for a 12" display.

Screw, M2.5× 8mm

Note:

13-inch display shown. For a 12-inch display, the display cables differ.

Figure 2-8. Removing the Icon PCA and Display Assembly

Reassembly Notes

∙After connecting the inverter/MB cable from the right hinge, carefully dress the wires into the cutout and support in the top case.

Caution

∙For a 12-inch display, tuck the excess length of the LCD flex cable under the keyboard. The cable could be damaged if there is excess length in the hinge area.

∙Use a 5 mm screw to fasten the LCD cable. If you use a longer screw, it will damage the motherboard.

Do not overtighten the screws for the LCD cable. They fasten to a sheet-metal bracket and the threads could strip.

∙Insert the right end of the icon PCA between the plastic tabs on the case. Check that the IR/icon cable is not pinched and emerges above the PCA.

∙Slide the open end of the hinge cover onto the hinge, then lift the closed end over the bump and slide it in.

HP OmniBook 2100/3000/3100

Removal and Replacement 2-11