IMPORTANT: Make special note of each screw and screw lock size and location during removal and replacement.
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 46).
5.Remove the service door (see Service door on page 52).
6.Remove the following components:
a.Upgrade bay device (see Upgrade bay device on page 68).
b.Keyboard (see Keyboard on page 72).
Remove the memory module:
1.Spread the retaining tabs (1) on each side of the memory module slot to release the memory module. (The edge of the module opposite the slot rises away from the computer.)
2.Remove the memory module (2) by pulling the module away from the slot at an angle.
NOTE: Memory modules are designed with a notch to prevent incorrect insertion into the memory module slot.
Reverse this procedure to install memory module.
Component replacement procedures | 75 |
