Battery Replacement
8.Locate the battery and battery holder on the system board.
9.Release the battery latch and lift the battery out of the holder 1.
10.Holding the replacement battery with the positive side up, push the battery down until the latch snaps over the upper edge of the battery 2.
Replacing the Battery
✎After the battery has been replaced, use the following steps to complete this procedure.
11.Replace the power supply:
a. Gently place the left side of the power supply in place.
a.Rotate the right side of the power supply down until it stops.
b.Slide the power supply back until it locks in place.
12.Replace the MultiBay daughter card by carefully aligning the card with the connector slot and pressing the card firmly into place.
13.Replace the MultiBay drive.
Hardware Reference Guide | www.hp.com |
